9.6 Manual mode
Select this menu to call up presetted positions of channel effects or direct control channel effects.
PrE.C. --- Presetted effect control.Select this menu to call up presetted positions of the channel effects.
Man.C. --- Manual effect control.Select this menu to control effects by control buttoms on the control board.
Func. a special function C.SPd. a CMY/dimmer speed
Macr. CMY macros EFFE. an effect wheel
Colo. a colour wheel Zoom a zoom
Col.F. a colour ne F.Zom. a ne zoom
CYAN cyan lamellas Stro. a strobe/shutter
MAGE. magenta lemellas dimr a dimmer
YELL. yellow lamelas F.dim. a ne dimmer
9.7 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you some possibilities of using
ColorMix 575 AT.
9.8 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and modifying current pro-
grams.
Audi --- Music trigger.Select this function to enable the sound control of the running programs via the built-in microphone.
Auto --- Presetting playback.This function allows you to select the program which will be played in the stand-alone mode
after switching the xture on.Selected program will be played continuously in a loop.
d.Abl --- The option disables "Auto" function.
tESt --- The option will start built-in test program.
PrG. 1 --- The option will start created program No.1
PrG. 2 --- The option will start created program No. 2
PrG. 3 --- The option will start created program No. 3
Note:If the xture operates in the controller mode ( DMX controller is connected) and any program from this menu is selected ,in this
case the xture will not respond to the DMX controller after switching on and will play selected program.
PLAY --- Playing program.Select this menu to run a bilt-in program or the 3 freely-programmable programs in a loop.
tESt --- The option starts built-in test program.
PrG.1 --- The option starts created program No. 1
PrG.2 --- The option starts created program No. 2
PrG. 2 --- The option starts created program No. 3
Select the program you wish and press [ENTER].The selected program starts running.By Pressing [ENTER] again is possible to pause
the program running.
Edit --- Editing program.Select this menu to edit or create the program.The ColorMix 575 AT has one built-in program and the 3 free
programs,each up to 99 steps.Each program step has a step time.Step time-the time,during which effects last in the current step.
If the xture is set as a master ,then you may edit any program in the slaves.You can't edit programs on the slave xtures from their
control panels if the master xture is switched on and connected to the slaves (editing is possible by the master control panel only).
Procedure:
1. Press [UP] or [DOWN] to select the program you want to edit ("PrG.1" - "PrG.3") and press [ENTER].
Kommentare zu diesen Handbüchern