Robe Color mix 575 AT Spezifikationen PDF herunterladen (Seite 11)

4.6 DMX 512 connection, master/slave connection

The wires must not come into contact with each other, otherwise

the xtures will not work at all, or will not work properly.

Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with the xture or one xture

with another.

Occupation of the XLR-connection:

DMX - output DMX-input

XLR mounting-socket: XLR mounting-plug:

Building a serial DMX-chain:

If you are using the standard controllers, you can connect the DMX-output of the controller directly with the DMX-input of the rst xture

in the DMX-chain. If you wish to connect DMX-controllers with other XLR-outputs, you need to use adapter-cables.

Connect the DMX-output of the rst xture in the DMX-chain with the DMX-input of the next xture. Always connect output with the

input of the next xture until all xtures are connected.

Caution: At the last xture, the DMX-cable has to be terminated with a terminator. Solder a 120 Ohm resistor between Signal (–) and

Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last xture.

Building a master/slave-chain:

Connect the DMX-output of the master xture in the data-chain with the DMX-input of the rst slave. Always connect output with the

input of the next slave until all slaves are connected (up to 9 xtures).

Caution:It’s necessary to insert the XLR termination plug (with 120 Ohm) into the input of the master xture and into the output of

the last slave xture in the link in order to ensure proper transmission on the data link.

1 - Ground

2 - Signal (-)

3 - Signal (+)

1 - Ground

2 - Signal (-)

3 - Signal (+)

Master/slave operation

Controller operation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Keine Kommentare

Robe Color mix 575 AT Spezifikationen Seite 11