Robe 575EAT Spezifikationen PDF herunterladen (Seite 12)

4.8 DMX-512 connection/connection between fixtures

The fixture is equipped with both 3-pin and 5-pin XLR sockets for DMX input and output.The sockets are wired in

parallel.

Only use a shielded twisted-pair cable designed for RS-485 and 3-pin or 5-pin XLR-plugs and connectors in order

to connect the controller with the fixture or one fixture with another.

DMX - output DMX-input

XLR mounting-sockets (rear view): XLR mounting-plugs (rear view):

If you are using the standard DMX controllers, you can connect the DMX output of the controller directly with the

DMX input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other XLR-outputs,

you need to use adapter-cables.

Building a serial DMX-chain:

Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always

connect one output with the input of the next fixture until all fixtures are connected.

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 Ω resistor

between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

1 - Shield

2 - Signal (-)

3 - Signal (+)

4 - Not connected

5 - Not connected

1 - Shield

2 - Signal (-)

3 - Signal (+)

4 - Not connected

5 - Not connected

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Keine Kommentare

Robe 575EAT Spezifikationen Seite 12