Robe DMX Control 1024 Bedienungsanleitung

10manual on using the memory card drive for more information.LOAD MEMORY FILEThis allows you to restore the memory from a backup that was made using t

11NUMBER SWITCHES 1-48The large group of switches on the left side of the panel that are numbered 1-48 are multi-purpose. The functionswitches that ar

12the faders is used to select which bank of 8 channels is currently active. The LED to the left of the faders showsthe current bank. The channel numb

13under the fade time or use data wheel #3 to change the crossfade time for this scene. You can also use akeyboard to enter the fade time.To record th

14If you press “yes” the scene will be erased. You can then select additional scenes to be erased or youcan press “record” to exit record mode.Note:

15currently filled.After saving a preset, record mode stays on allowing you to continue to record more presets. Any channelchanges that were made sinc

16any channel levels. After making changes you can store it at the same or at a new location by pressing any presetnumber. You can also use this metho

17At any time while recording the chase you can enter a speed value, a fade value and a name for the chase. Usethe cursor switches to move the cursor

18Note: It can take up to 30 seconds to overwrite or erase a chase depending on how much of the memory iscurrently filled.EDITING CHASESTo edit a chas

19The display will show the current step that is ready to be recorded along with the scene page and scene numberin that step. The word “Empty” will ap

2User manualDMX CONTROL 1024Table of contentsSAFETY INSTRUCTIONS ...

20PLAYING SHOWSTo playback a show, press the “show” switch, and then select the desired page and number switch. The displaywill show the page, show nu

21You have many more options when calling scenes in preview mode. In addition to being able to select sceneswith the number switches you can also use

22remove dimmers from the scene by pulling their levels down to 0, they will still be in the scene and they will havethe value 0. Also be aware that i

23SOFTWARE UPDATEInsert a card with the software update file on it. The file must have the name SD2Vxxx.txt (xxx is the versionnumber). Go to the DMX

24TECHNICAL SPECIFICATIONSTotal number of control channels: 1024Maximum number of programmable Chases: 1152Maximum number of programmable Scenes: 4752

25APPENDIX - FIXTURE LIBRARYThe following is the list of ”built in” lighting fixtures in the DMX Control 1024 fixture library. Fixtureprofiles are ava

26

3BLACK SWITCH ... 12SCENES ...

4Keep this device away from rain and moisture!Unplug mains lead before opening the housing!FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY

5Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, disconnectfrom mains immediately. Please let the

6OVERVIEWThe DMX Control 1024 is a lighting controller based on the successful and simple to use Show Designer. TheDMX Control 1024 expands on the exi

7selected by pressing and holding down the “add” switch while selecting these last items from the menu list. Thisis a safety feature for the benefit o

8MODIFY FIXTUREThis allows you modify some of the channel attributes of a fixture. You can also use this to create a new fixturethat isn’t in the libr

9“Snap before fade” will cause the channel to jump immediately to the next scene level as soon as the new sceneis called. Use this setting for channel