Robe CitySource 96W Spezifikationen PDF herunterladen (Seite 17)

CitySource 96 (Single colour)

List of control channels:

“COL.1” - LEDs saturation-array1

“COL.2“ - LEDs saturation-array2

“Stro.“ - a strobe, shutter

“dimr“ - a dimmer

“F.dim” – a fine dimmer

4. Press the ENTER button and use the UP/DOWN buttons to set value , press the ENTER button to confirm it.

6. 5 Test sequences

Use this menu to run demo-test sequences without an external controller, which will show you some possibilities

of using the CitySource 96.

6.6 Stand-alone setting

The fixtures on a data link are not connected to the controller but can execute pre-set programs which can be

different for every fixture. “Stand-alone operation” can be applied to the single fixture or to multiple fixtures

operating synchronously.

Synchronous operation of multiple fixtures requires that they must be connected on a data link and one of them is

set as a master (“MASt“) and the rest as the slaves (“SLA“). Up to 32 fixtures can be connected in a master/slave

chain. Only one fixture can be set as the master.

Note: Disconnect the fixtures from the DMX controller before master/slave operating, otherwise data collisions can

occur and the fixtures will not work properly. See the chapters “Stand-alone operation“ and “ Master/slave

connection“.

Auto. --- Automatic playback. This function allows you to select the program which will be played after switching

the fixture on. Selected program will be played continuously in a loop.

1. Use the UP/DOWN buttons to find “ St.AL.“ menu.

2. Press the ENTER button.

3. Use the UP/DOWN buttons to select “ Auto“ item.

4. Press the ENTER button.

5. Use the UP/DOWN buttons to select desired program.

6. Press the ENTER button to confirm the choice.

PLAY --- Playing program. By enter to this menu a complete overview of all programs is offered, from which the

program to be run can be selected.

1. Use the UP/DOWN buttons to find “ St.AL.“ menu.

2. Press the ENTER button.

3. Use the UP/DOWN buttons to select desired program.

4. Press the ENTER button. The selected program runs in a loop.

Edit --- Editing a program. The fixture offers 3 freely editable programs (EPG.1-EPG.3) each up to 68 steps. Every

program step includes a fade time-the time taken by the step´s channel status to reach the desired level and a

step time-the total time occupied by the step in the program.

E.g. If “F.tim.“=5 second and “S.tim.“=20 second, effects will go to the desired position during 5 seconds and after

that they will stay in this position for 15 seconds before going to the next prog. step

1. 1. Use the UP/DOWN buttons to find “ St.AL.“ menu and press the ENTER button.

2. Use the UP/DOWN buttons to select “Edit“ menu and press the ENTER button.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Keine Kommentare

Robe CitySource 96W Spezifikationen Seite 17